Irox PE101S Instructions d'exploitation télécharger pdf (Page 7)

4.2 The function STEP COUNTER

In this function you can view all the steps you have made.

Deleting the step counter

To delete accumulated data press and hold the RESET button in this mode for 2 seconds or until the value

changes to zero.

All records will be deleted including the calculated distance and calories displayed.

First steps

The pedometer registers every movement but it takes 3-5 seconds to display the first values. This means if

you only make a short movement (less than 3-5 seconds) it will not count anything. But if you stand up

thereafter and constantly move about the first steps you made will appear and the PE101S will continue

counting from there. So basically no steps are lost.

4.3. The function DISTANCE

The distance requires the input of your stride in cm.

Measuring stride

To measure your stride, proceed as follows:

First you take ten steps like you normally walk measure the distance you walked and divide this by ten.

Example:

You measure 6.2 metres. 6.2m / 10 (number of steps) = 0.62m (Enter stride: 62 cm).

Setting your step length:

- Press MODE, until you see KM on the right side of the display.

- Press and hold the SET button for 2 seconds or until a blinking number appears and the indication CM is

indicated on the right side of the display.

Following settings can now be made:

MODE: With this button you can now set your stride in CM (adjustable from 30 – 180 cm). If you hold the

button down the numbers will run through faster.

SET: Finish and accept settings.

If, while in the set mode, no button is pressed during a time frame of 30 seconds the adjustments made will

automatically be saved and the device will return to the distance mode.

Deleting the shown distance (km)

Press and hold the RESET button in this mode for 2 seconds or until the value changes to zero.

All other records (steps, kcal) will also be deleted!

1 2 3 4 5 6 7 8

Pas de commentaire

Irox PE101S Instructions d'exploitation Page 7